Hi SAP gurus,
I am new to this discussion form and this is my 1st question, so kindly forgive me if I had done any mistakes in asking my question.
I am trying to install and configure a report generating tool(ReadSoft Performance Analytics) in the BW system.
As a prerequsit we have first activate few DataSource on the ECC side.
(2LIS_02_HDR,2LIS_02_ITM,2LIS_02_ACC,2LIS_02_SRV).
but when I run the extractor checker(RSA3) I am getting pop up: 0 records fetched.
I searched in EKKO table in se16 there are about 19,000 entries.
steps I followed:
1. activated the DataSource in RSA5
2. activated the extraction structure in LBWE
3. Tried to fill the setup table OLI3BW and I getting a error pop up: No extraction active or no BW connected.
4. Tried to delete the setup table (LBWG) for application 02 and refill the setup table again, still getting the same error.
ECC and BW are connected, this DataSources are active in the BW side also,since we are not able to extract the data in the ECC itself we are not able to replicate the data on the BW side.
Thanks in Advance.
Regards,
Sravanthi